Amendment 3 BS 7671 Requirements for Electrical Installations IET Wiring Regulations
The British Standards Institution (BSI) publishes standards and provides a range of books, self-assessment tools, conferences and training services. It also represents UK economic and social interests in European and international standards organisations.
BS 7671 Requirements for Electrical Installations. IET Wiring Regulations, sets the standards for electrical installations in the UK. It is published by BSI and the Institution of Engineering and Technology (IET).
On January 1 2015, BS 7671:2008+A3:2015, Amendment No. 3 to the 17th Edition was published. It included changes relating to:
- Consumer units.
- Wiring in escape routes.
- Changes to earth fault loop impedances for all protective devices.
- Updated EIC and EICR forms.
- Changes to definitions.
Amendment 3 came into effect on 1 July 2015, however, the changes in relation to consumer units did not come into effect until 1 January 2016.
From this point, consumer units and similar switchgear assemblies have to comply with BS EN 61439-3 Low-voltage switchgear and controlgear assemblies. Distribution boards intended to be operated by ordinary persons (DBO).
Consumer units are pieces of equipment located where the incoming mains supply is fed to the individual domestic circuits. It typically includes protection and isolation hardware.
The amendment in relation to consumer units has been made in response to the increase in the number of fires which are thought to have involved consumer units with thermoplastic enclosures in which arcing on cables due to poor electrical connections caused overheating.
The amendment requires that consumer units contain fires, either being constructed using a non-combustible material or being contained within a cabinet constructed using a non-combustible material. It applies to consumer units and similar switchgear assemblies inside domestic premises. It does not apply to non-domestic installations or to outside installations.
[edit] Related articles on Designing Buildings
- Arcing.
- Articles by the Electrical Contractors' Association (ECA).
- Approved document P.
- Consumer unit.
- Electrical appliance.
- Electrical component.
- Electrical contractor.
- Electrical installation.
- Electrical safety.
- Electrician.
- Glossary of electrical terms.
- Grommet.
- IET announces release of 18th Edition Amendment 2.
- Institution of Engineering and Technology.
- International Organisation for Standardisation.
- Kitemark.
- Lock out tag out LOTO.
- Modular housing and electrical circuitry.
- Premises wiring system.
- Protected circuit.
- Publicly available specification.
- Ring circuit.
- Right to Repair law.
- Safe isolation for low voltage.
- SELECT Scotland's Electrical Trade Association.
- The Future of Electricity in Domestic Buildings.
Featured articles and news
Listed despite problems with its design.
Zen and the art of cycling exploration.
Design Council Homes Taskforce launched
To support government 1.5 million homes target within UK climate commitments.
The story of this knowledge quarter building.
In ecology, in hydrology, in biology and in architecture.
Creating environments that promote physical, mental, and social well-being.
UK cases of neutral current diversion
Research project looks for example contributions.
Overstocking and macro-economics cause a decline.
The 2024 update of the Common Assessment Standard
Demonstrating organisational capability’ to fulfil roles under the Building Safety Act.
56 recommendations for a better built environment
Published by the CIC ahead of the King’s Speech.
SkillELECTRIC Top 8 Competitors Named
in annual search for the UK’s best student electrician.
CIOB Diversity and Inclusion technical information sheet
Step-by-step guide on implementing D and I practices.
Conservation and the Indian City. Book review.
Reversibility in conservation ethics
Learning from painting conservation.
Where It's AT Podcast launched!
New CIAT Architectural Technology Podcast goes live.